Grab six large, pastured eggs, and use a pin or thumbtack to poke a hole in the fat “bottom” end of each of the eggs. Make sure the needle goes just far enough to piece the shell. (Quick tip: It’s easiest to keep the eggs upright by leaving them in the carton while you poke ’em.) 

Gently place the eggs in a deep, medium saucepan and fill it with cold water. Make sure the eggs are in a single layer, and at least 1 inch below the surface of the water.

For every 3 cups of water or so, add ½ teaspoon of baking soda. (The sodium bicarbonate’ll help the eggs separate from their shells, making them easier to peel.)

Place the uncovered pot on the stove and crank the heat to high. Once the water comes to a roiling boil, set a kitchen timer for 1 minute.

When the minute’s up, take the pot off the heat, cover it with a lid, and let the eggs sit in the hot water for 10 minutes. Set a timer – we want to be precise about this!

While you’re waiting, fill a large bowl with ice and water.

Then, once the timer goes off, remove the eggs from the pot and transfer them to the bowl of ice water. Completely submerge the eggs in the ice water for 5 minutes.

Then, fish the eggs out of the icy water, gently rap them against a hard surface to crack the shells, and peel each egg starting from the bottom end (where you poked the pinhole). Don’t wait until the eggs are completely cool – they should still be warm to the touch. The shells should come right off, with no fuss or muss.